Two separated digging tips form a visibly forked nose. Its wider profile is a different selection from a narrow penetration point; confirm the adapter and side-pin geometry.
An enclosed spin-on element with a threaded base and annular face gasket. Thread and gasket dimensions do not establish circuit suitability; confirm the housing specification before fulfilment.
Construction
Steel canister; enclosed pleated media; NBR base gasket
Dimensions
Height 145 mm; body diameter 93 mm; mounting thread 1–12 UNF; gasket ID 62 / OD 72 mm
A broad cupped flared lip and raised two-hole heel distinguish this bolt-on construction from socket teeth. Confirm the mounting face, hole centers and fastener clearance before fulfilment.
A mesh basket strainer with a threaded neck rather than pleated paper media. Check the suction assembly thread, clearance and service requirements; no mesh rating is asserted.
Construction
Stainless woven mesh; steel cage; threaded metal neck
Dimensions
Basket length 125 mm; diameter 70 mm; male neck thread 3/4 NPT; overall length 155 mm
Isolate the machine and support the attachment using the equipment procedure. Identify the adapter and retainer before removing a worn tooth. Measure the mating geometry, not a distorted tip alone. A wide flare and narrow penetration point are not interchangeable simply because both fit inside the bucket width.
Use the housing documentation to establish the required element and circuit limits. Compare the actual end format and seals as well as the outside diameter. A suction mesh basket, tank breather and supported cartridge serve different mounting positions; an attractive visual match is not evidence of safe substitution.
Include your selected SKU, exact measurements and the mounting or circuit requirements from your documentation. Machine details are helpful context, but do not replace an interface check. We confirm the essential selection information before fulfilment; no modification or forced fit should be needed to disguise a mismatch.
Keep the interface clean. Leave filter media protected until the housing is ready. Keep dirt and loose metal away from open hydraulic ports.
Inspect without altering. Compare dimensions and seals before installation. Do not grind a tooth, force a thread or oil-wet an element to test a guess.
Use the right service procedure. Depressurize hydraulic circuits and isolate attachments. Installation belongs with a competent technician and the equipment instructions.
Keep the reference and packaging. If a part is incorrect or damaged, stop before fitting and contact us. Clean, unused parts can be considered under the 30-day return terms.
Checkout receives your selection. Fit requirements and availability are confirmed in direct correspondence; bank-transfer instructions follow written confirmation. No card details are collected.
$18.95 delivery, free from $250. Contiguous US + DC. Preparation 1–2 and transit 3–5 business days: 4–7 total after fit/payment confirmation. Applicable tax included.
Request a discretionary return within 30 days. Parts must be unused and uninstalled. $18.95 return label; $0 restocking. Confirmed supply errors or defects are returned at our expense.
Not necessarily. The adapter/housing interface, retaining or sealing geometry and equipment requirements must be checked. A machine name alone cannot establish fit.
Are mounting hardware and a housing included?
No. Teeth are supplied without pins, locks, adapters or bolts. Filter listings supply the stated element, strainer or breather, not a separate housing. Refer to Included on the individual page.
Which filtration or pressure rating is stated?
No tested filtration efficiency, micron/beta or operating-pressure rating is asserted. Obtain the circuit and housing requirements before selecting an element.
07 / The next useful detail
A SKU. A measurement. A better starting point.
Send the mounting details, or quote your existing reference. Our first-response target is 2 business days.
